Feature Attributes the properties of a feature. For more information, see Attributes.
Geometry
Area
Reports the area enclosed by the current feature. If the current feature is not a closed polygon, then it is assumed to be closed by connecting a straight line from last point to first.
Reports the area enclosed by the current feature in square project units. This is useful for smaller areas where you don't want to report in Hectares or Acres.
Points
Reports the number of points (vertices) on a feature
Min. X
Reports the minimum X coordinate of the feature.
Max. X
Reports the maximum X coordinate of the feature.
Min. Y
Reports the minimum Y coordinate of the feature.
Max. Y
Reports the maximum Y coordinate of the feature.
Min. Z
Reports the minimum Z coordinate of the feature.
Max. Z
Reports the maximum Z coordinate of the feature.
RW Area
Reports the right of way area of the current feature. It is possible to change the right of way width in the General Setup dialog.
Properties
Selected
Indicates if the feature is selected or not selected. See Edit - Select Features for more information on selecting features.
Displayed
Indicates if the feature is visible or invisible. See the Feature Properties dialog for more information on changing feature properties.
Connected
Indicates if lines are drawn between feature points. See the Feature Properties dialog for more information on changing feature properties.
3D
Indicates if the feature has elevations. See the Feature Properties dialog for more information on changing feature properties.
Breakline
Indicates if the feature will be used for breakline creation in the TIN. See the Feature Properties dialog for more information on changing feature properties.
Modeled
Indicates if the feature will be included in the creation of the TIN. See the Feature Properties dialog for more information on changing feature properties.
Negative Area
Indicates if the area of this feature will be subtracted when total areas are reported . See the Feature Properties dialog for more information on changing feature properties.
Surface/Vol. Boundary
Indicates if the feature will have attributes for surface area, slope and volumes. See the Feature Properties dialog for more information on changing feature properties.
TIN Boundary
Indicates if the feature will be used as TIN limits. See the Feature Properties dialog for more information on changing feature properties.
Reports the total volume above Surface A (the current terrain), below Surface B and bounded by the selected feature(s). This only applies to volume boundary features. See Volumes for more information.
Vol. Below
Reports the total volume below Surface A (the current terrain), above Surface B and bounded by the selected feature(s). This only applies to volume boundary features. See Volumes for more information.
Surf. Area
Reports the total surface area bounded by the selected feature(s). This only applies to volume boundary features. See Surface Properties for more information.
Av. Slope
Reports the average slope (of the slope of steepest descent) of the surface area bounded by the selected feature(s). This only applies to volume boundary features. See Surface Properties for more information. The slope is weighted by the plan area.
Av. Slope Dir.
Reports the average azimuth (of the slope of steepest descent) of the surface area bounded by the selected feature(s). This only applies to volume boundary features. See Surface Properties for more information. The azimuth is weighted by the plan area.
