1.3.13.7. Modifying the Vertical Alignment in the Section Window

Location

^{User guide}

Index

Modifying the Vertical Alignment in the Section Window

To move the Vertical Alignment in the Section Window:

1. Activate the Section Window by clicking on it. Select menu View - Section Options and make sure Vert Alignment check box is selected.

2. Select Edit - Tool Selection - Add/Edit IP Tool or click on the Add/Edit IP button on the Mode Toolbar. You are now ready to edit an L-line point.

3. Position the cursor box over at the center of the road (at subgrade) and click the left button on the mouse.

4. Move the cursor box vertically until you are at the new desired position. Click the left button on the mouse again. The a new profile point will be added if one didn't exist before and the cross section will be updated.

NOTE: If the section which you are modifying is on a vertical curve you will be prompted to delete the curve before the alignment is modified.