The Fill Material Assignments dialog is accessed from the Edit - Assign Parameters by Range. This dialog allows you to assign fill material to station ranges along the alignment. The fill material will determine the fill slope angle if the Template slope is set to AUTO (see Template Editor dialog for more information).
New Range
NOTE: To delete an interval, override it with another one. After modifying an interval, you must click the Add button in order for the changes to be stored.
Fill Material
Select the Fill Material to apply to this range. The plus button next to Fill Material opens up the Ground Type Editor dialog which allows creation and editing of fill types.
From Stn
Enter a start station (L-line). If no station is specified, the From Stn is assumed to be the beginning of the road.
To Stn
Enter an ending station (L-line). If no station is specified, the To Stn is assumed to be the end of the road.
Add
This will assign the fill type to the specified range and display in the dialog box. You can Add more than one range, if you wish, before you press OK.
Ranges
This area displays all Fill Material assignments for the whole road. Highlighting one of the Fill Material assignments will allow you to modify the values in the New Range area above.
OK
This will exit the dialog box; In addition, reporting points will be inserted just before (-.5 units) and just after (+.5 units) any boundaries between fill types.
After completing this option the user is prompted to "Recalculate the road alignment? (Yes / No)". If yes response is given, all cross sections will be recalculated. If a fill type has been inserted and the alignment is not recalculated, cross section and earthwork data will be invalid.
Cancel
Ignore any changes and exit.
NOTE: To delete a fill type interval, override it with another one.
Other Materials
This option allows you to change, the fill material for other template layers (non SG layers).
