This dialog box allows you to explicitly enter offsets from the P-line to the L-line. This dialog is accessible from the Edit - Enter P-Line Offsets menu and is only available if a P-Line is defined and the P-Line Design function group is enabled.
Profile Point Check Box
If selected, a profile point will be created (if one doesn't already exist) with the specified vertical offset. Note if the current station is on a vertical curve this Check Box will be disabled.
Vertical Offset
Enter the offset from the P-line to the L-line. A negative offset indicates the L-line is below the P-line.
Plan Point Check Box
If selected, a plan point will be created (if one doesn't already exist) with the specified horizontal offset. Note if the current station is on a horizontal curve this check box will be disabled.
Horizontal Offset
Enter the offset from the P-line to the L-line. A negative offset indicates the L-line is on the left side of the P-line. A positive offset indicates the L-line is on the right side of the P-line.
